B030 Ultra small bearing pullerDetailed product description：

The bearing specifications for disassembling the B030 ultra small bearing puller can refer to the GB bearing specification comparison table for the FY-S series bearing puller. Firstly, carefully identify the bearing to be disassembled (with measurable outer diameter), compare it with the specification table on the nameplate of the money box, and confirm that it has this specification. Then, open the cover and look at the placement diagram on the inside of the cover to take out the required specification. Then disassemble the puller, remove the "sleeve clamp", take off the two halves of the circular arc "pulling claws" and install them on the bearing that needs to be disassembled. The "thin" end of the claw hook is hooked onto the inside of the bearing and fixed with fingers. Place the "pulling body" (together with the "bolt") on the "pulling claw", make the claw hook at the other end embedded in the groove cleaning of the "pulling body", adjust the "bolt", make the steel ball at the end gently press against the central hole of the shaft, close the other half of the arc pulling claw, cover the hoop outside the two closed semicircular arc pulling claw, fix it, use two appropriately sized mobile hands, fix the square head of the pulling body with the left hand, screw the hexagon head of the bolt with the right hand, and the bearing is easily removed.