The ZDR type conical rotor braking three-phase asynchronous motor can be started with a series resistor, allowing its mechanical characteristics to be artificially softened at will. It can provide a large starting torque at a small starting current, and can be adjusted in a small range of speed. The starting is smooth and the braking is safe and reliable. And it is matched with a reducer to drive lifting and transportation machinery, high-efficiency machinery, and other transmission machinery that require rapid braking. When the starting load is large and the distribution capacity is insufficient, and the cage type conical motor cannot start smoothly, this series of motors can be used. This series of electric machinery uses a 50HZ, 380V power supply. The benchmark working system is S3, with a load duration rate of 25% and a starting frequency of 120 times per hour when powered on.

Structure Introduction:
This series is a horizontal motor that uses a conical surface brake. The output end shaft is extended as a rectangular spline or flat key, and the base does not have a foot. The front end cover has a flange (flange type), and the installation hole is on the flange of the front end cover. This series of motors is a closed structure with a protection level of IP44. The cooling method is self fan cooling IC0141, and there are two insulation levels: B or F.

Main technical parameters:

Appearance and installation dimensions (unit: mm)

ZDR type cone-shaped rotor brake three-phase asynchronous motor