NFC9180 Anti glare floodlightDetailed product description：

survey:
The NFC9180 anti glare floodlight is suitable for floodlighting in various factory areas, workshops, stations, large facilities, venues, and other places.

Performance:
Using efficient and long-lasting gas discharge light sources, the lifespan can reach up to 28500 hours; Power factor greater than 0.9, high luminous efficiency, and good transparency.
Using advanced optical and lighting principles to optimize the design of transparent components, the light is soft, the illumination is uniform, there is no glare or ghosting, which can effectively avoid discomfort and fatigue for workers and construction personnel.
Integrated and multiple anti vibration structure design ensures long-term fault free operation in high-frequency and multi frequency vibration environments.
High strength aluminum alloy shell is selected for special sealing and surface coating treatment, which can be used for a long time under harsh conditions such as high temperature, humidity, and various corrosives.
Multiple installation methods such as pedestal, ceiling, and suspended ceiling are available to meet the lighting needs of different work sites.

Two uses:
1. Determine the installation position of the lighting fixtures, choose the appropriate installation method, and prepare the corresponding length of three core cable with a diameter of 6~8mm according to the distance from the lighting fixtures to the 220V power supply contact;
2. Open the two locking buckles on the lamp holder to open the back cover. Thread one end of the prepared three core cable through the inlet, connect the live wire (L) to the "L" terminal, the neutral wire (N) to the "N" terminal, and the ground wire (PE) to the "PE" terminal. Then tighten the cable at the inlet with a compression nut, close the back cover, fasten the locking buckle, and finally connect the other end of the three core cable to the power supply to achieve lighting.
3. When replacing the light bulb, follow instructions 2 to open the back cover, turn the lamp holder to the right, and gently pull it out of the lamp cover. Unscrew the old light bulb from the lamp holder and replace it with a new one.
4. Installation:
Ceiling installation: First, use 4 M8 bolts to fix the lifting adapter plate on the lamp. Thread the three core cable through the G3/4 pipe thread, through the circular hole on the side and the inlet on one side of the lamp holder, and connect it to the lamp. Then, screw the G3/4 pipe thread of the lamp and the wiring steel pipe with standard G3/4 pipe thread together.
Ceiling installation: According to the installation hole size of the lamp, drill corresponding installation bolt holes at the position where the lamp is to be installed, and fix it with M8 bolts.
5. Multiple lights in parallel.

Three notes:
1. During transportation, the lamps shall be installed in the cartons provided, and foam shall be added for shock absorption.
2. When in use, there is a certain temperature rise on the surface of the lamp, which is a normal phenomenon; The center temperature of the transparent component is high and should not be touched.
3. When replacing light bulbs, use bulbs of the same type and power; If the type or power of the light bulb is changed, the matching ballast should be replaced accordingly.

Technical parameters of NFC9180 anti glare floodlight:
Rated voltage: 220VAC 50Hz
Shell protection: IP65
Inlet thread: G3/4
Cable introduction: 6~8mm in diameter
Dimensions: 226 × 220 × 300mm
Total weight: 6Kg