SH/BFC8130 Explosion proof LampDetailed product description：

survey:
SH/BFC8130 Explosion proof Lamp (Ⅱ C) is suitable for various indoor work sites in flammable and explosive places, and is used as a fixed lighting for the interior.

Performance:
Excellent explosion-proof performance, can work safely and reliably in flammable and explosive hazardous areas.
Using high-intensity gas discharge as the light source, the brightness is soft, the color rendering is good, and the average service life is over 10000 hours.
Excellent structural design and surface sealing treatment, sturdy and durable, dustproof and anti-corrosion.
Suspended, ceiling mounted, and wall mounted installations are easy and convenient to operate.

Two uses:
1. According to the actual lighting needs of the work site, determine the installation position and method of the lamps and ballasts, and then prepare three core cables of corresponding lengths according to the distance from the lamps to the ballast contacts and the distance from the ballast to the 220V power contacts (cables provided with the lamps can be used if the distance does not exceed 2 meters).
2. When the distance between the lamp and the ballast contact exceeds 2 meters, the three core cable needs to be replaced. Use an Allen wrench to unscrew the six hex bolts on the lamp housing, pull out the lamp body, remove the three core cable that comes with the lamp, and then connect the prepared three core cable according to the original wiring method.
3. Use a socket wrench to unscrew the fastening bolts on the ballast box cover, remove the box cover, and introduce one end of the three core cable of the lamp into the ballast chamber through the introduction device of the ballast output port. Connect the red, black (or blue), and yellow green wires to the 4th, 5th, and 6th terminals of the ballast respectively, and then tighten the compression nut.
4. Insert one end of the prepared three core power cable into the ballast chamber through the introduction device of the ballast input port, and then connect the L wire (live wire), N wire (neutral wire), and ground wire to the wiring terminals of positions 1, 2, and 3 of the ballast respectively, and tighten the clamping nut.
5. Close the ballast box cover and tighten the fastening bolts, and finally connect the other end of the three core cable to a 220V power supply according to explosion-proof requirements.
6. When replacing a light bulb, first cut off the power, check if the hanging chain is properly attached, and then use an Allen wrench to unscrew the six hexagon bolts on the light housing. Carefully pull down the light body to separate it from the lamp head housing, unscrew the old light bulb and replace it with a new one.

Warning:
1. It is strictly prohibited to turn on lighting fixtures with electricity on.
2. When installing lighting fixtures, be sure to ground the lamp housing and make it secure.

Three notes:
1. When installing and maintaining lighting fixtures, the power must be cut off.
2. When in use, there is a certain temperature rise on the surface of the lamp, which is a normal phenomenon. The center temperature of the transparent part is relatively high and should not be touched.
3. The ballast provided by our company must be used.
4. When using wall mounted installation, the installation angle should not exceed 45 °.
5. The starting current of the lamp is 2.5 times the normal operating current, and the starting current of the 250W lamp is 2.8A.
6. The lamp head housing is equipped with shock absorbing foam, which must be taken out when it is installed and used for the first time.

Technical parameters of SH/BFC8130 internal explosion-proof lamp (IIC):
Rated voltage: 220VAC 50Hz
Shell protection: IP65
Inlet thread: G3/4
Cable introduction: 8mm to 14mm
Dimensions: 540 × 364 × 192mm
Total weight: 11Kg