SH/BNC6230 Explosion proof and Anti glare Flood LightDetailed product description：

survey:
SH/BNC6230 Explosion proof and Anti glare Flood Light (IIC) is suitable for fixed lighting in flammable and explosive places, petrochemical facilities, offshore oil platforms, oil stations, oil depots and other special places, facilities and shipbuilding industries.

SH/BNC6230 Explosion proof and Anti glare Flood Light (IIC) Performance:
Excellent explosion-proof performance, can work safely and reliably in flammable and explosive hazardous areas.
Using high-intensity gas discharge lamps as light sources, with high luminous efficiency, uniform illumination, and an average service life of over 10000 hours.
The shell is made of lightweight alloy material and treated with high-tech spraying, which is wear-resistant, corrosion-resistant, waterproof and dustproof; The exquisite structural design expands the heat dissipation space, reduces temperature rise, and improves the service life of the light source.
Small in size and light in weight, it can be installed in various ways such as ceiling mounted, hanging rod mounted, and lamp post mounted, with simple and convenient operation.
Has good electromagnetic compatibility and will not cause interference to the surrounding environment.

Two uses:
① Determine the installation location of the lighting fixtures based on the on-site environment and lighting needs, and prepare three core cables of corresponding length according to the distance from the lighting fixtures to the 220V power supply.
② Thread the 2-meter three core cable provided with the lamp through the steel pipe and secure the lamp.
③ Open the fixing screws on the upper cover of the ballast box, loosen the compression nut for the cable entry of the ballast box, and thread the lamp cable and the power cable into the ballast box through the compression nut respectively.
④ Connect the lighting fixtures and power cables according to the wiring diagram inside the box, close the upper cover of the ballast box, and tighten the screws. Connect the other end of the input cable of the ballast box to a 220V power supply according to explosion-proof requirements for lighting.
⑤ When replacing the light bulb, simply rotate the lamp housing clockwise to separate it from the upper cover, remove the bulb, replace it with a new bulb, and install the lamp in the opposite direction.
Warning: 1. It is strictly prohibited to open with electricity. 2. Non professionals are not allowed to install cables or dismantle lighting fixtures at will.

Three notes:
① When in use, there is a certain temperature rise on the surface of the lamp, which is a normal phenomenon; The center temperature of the transparent component is high and should not be touched.
② When replacing the light bulb, the same model of light bulb should be used; If the bulb model or power is changed, the ballast should be replaced accordingly.
③ When the distance between the lamp and the ballast exceeds 2 meters, the cable needs to be replaced.

Four technical parameters:
Rated voltage: 220VAC 50Hz
Shell protection: IP65
Inlet thread: G3/4
Cable introduction: 8mm to 14mm
Dimensions: φ 181 × 265mm
Total weight: Lamp: 3.2Kg, ballast box: 4.2Kg