CS2000FA series Hall current sensorDetailed product description：

CS2000FA series Hall current sensor

A current sensor based on the open-loop principle of Hall effect can measure currents of DC, AC, pulse, and various irregular waveforms under electrically isolated conditions.

Electrical parameters

	model	CS400FA	CS600FA	CS800FA	CS1000FA	CS1500FA	CS2000FA
IPN	Primary rated input current	four hundred	six hundred	eight hundred	one thousand	one thousand and five hundred	two thousand	A
IP	Measurement range of primary current	0～±800	0～±1200	0～±1600	0～±2000	0～±2500	0～±2500	A
VOUT	Rated output voltage on the secondary side	4±1%						V
VC	power supply voltage	±12～±15(±5%)						V
IC	current consumption	VC=±15V <25						mA
Vd	insulation voltage	5KV effective value/50Hz/1 minute between the primary and secondary circuits
εL	linearity	<1						%FS
V0	Zero offset voltage	TA =25℃ <±25						mV
VOM	Magnetic misalignment voltage	IPN→0 <±25						mV
VOT	Unbalanced voltage temperature drift	IP=0 TA =-25～+85℃ <±1						mV/℃
Tr	response time	≤7						μs
f	Band width (-3dB)	DC～20						kHz
TA	Working environment temperature	-25～+85						℃
TS	Storage environment temperature	-40～+100						℃
RL	load resistor	≥10K						Ω
	standard	Q/3201CHGL02-2007

CS2000FA series Hall current sensor external dimensions (mm)

Pin output: 1,+15V 2, -15V 3, Vout 4, 0V (power ground) OFS, zero adjustment GIN, amplitude adjustment
Lead output: red,+15V blue, -15V yellow, Vout black, 0V (power ground)

Instructions for Use
1. Incorrect wiring may cause damage to the sensor. After the sensor is powered on, when the measured current passes through the direction of the sensor arrow, the in-phase voltage value can be measured at the output terminal.
2. The output amplitude of the sensor can be adjusted appropriately according to user needs.
3. Sensors with different rated input currents and output voltages can be customized according to user needs.