CS2000EK2 Series Hall Removable Current SensorDetailed product description：

Product Description: How to Translate
The CS2000EK2 series Hall detachable current sensor applies the open-loop principle of Hall effect to measure currents of DC, AC, pulse, and various irregular waveforms under electrical isolation conditions.

CS2000EK2 series Hall detachable current sensor electrical parameters

	model	CS300EK2	CS400EK2	CS600EK2	CS800EK2	CS1000EK2	CS2000EK2
IPN	Primary rated input current	three hundred	four hundred	six hundred	eight hundred	one thousand	two thousand	A
IP	Measurement range of primary current	0～±600	0～±800	0～±1200	0～±1600	0～±2000	0～±3000	A
VOUT	Rated output voltage on the secondary side	4±1%						V
VC	power supply voltage	±12～±15(±5%)						V
IC	Current consumption	VC=±15V <25						mA
Vd	insulation voltage	5KV effective value/50Hz/1 minute between the primary and secondary circuits
εL	linearity	<1						%FS
V0	Zero offset voltage	TA=25℃ <±25						mV
VOM	Magnetic misalignment voltage	IPN→0 <±25						mV
VOT	Unbalanced voltage temperature drift	IP=0  TA=-25～+85℃ <±1						mV/℃
Tr	response time	≤7						μs
f	Band width (-3dB)	DC～20						kHz
TA	Working environment temperature	-25～+85						℃
TS	Storage environment temperature	-40～+100						℃
RL	load resistor	≥10K						Ω
	standard	Q/3201CHGL02-2007

Dimensions (mm)

Pin Description: 1:+15V 2: -15V 3: Vout 4:0V (Power Ground) OFS: Zero Point Adjustment GIN: Amplitude Adjustment
Lead output wiring: Red:+15V Blue: -15V Yellow: Vout Black: 0V (power ground)

Instructions for Use
1. Incorrect wiring may cause damage to the sensor. After the sensor is powered on, when the measured current passes through the direction of the sensor arrow, the in-phase voltage value can be measured at the output terminal.
2. The output amplitude of the sensor can be adjusted appropriately according to user needs.
3. Sensors with different rated input currents and output voltages can be customized according to user needs.