MFZ12-YC series DC wet valve electromagnetDetailed product description：

The MFZ12-YC series DC wet valve electromagnet is suitable for control circuits with DC 50H and voltage up to 220V. As a power component of hydraulic solenoid directional valve. Can be matched with YUKEN six and ten way diameter junction box threaded electromagnetic directional valve from Japan.

Normal working conditions
Can be installed in any direction.
There should be no gas or dust in the usage environment that can corrode metals and damage insulation. Otherwise, it may affect the product's lifespan.
Electromagnets are suitable for long-term and intermittent cycle working systems.
The reasonable fluctuation range of power supply voltage is 85% -110% (special requirements can be raised when ordering).
The enclosure protection level is IP65.

Main technical parameters of MFZ12-YC series DC wet valve electromagnet

model	Rated voltage (V)	Rated suction (N)	Rated stroke (mm)	Full stroke (mm)	Power consumption (W)	Enduring static oil pressure (MPa)	Operating frequency (T/h)
MFZ12-22YC	24 110	≥22	two point eight	≥6	≤30	twenty-one	twelve thousand
MFZ12-25YC	12 24 110 220	≥25	two point eight	≥6.1	≤26	twenty-one	twelve thousand
MFZ12-37YC	12 24 110 220	≥37	two point eight	≥6.1	≤30	twenty-one	twelve thousand
MFZ12-60YC	12 24 110 220	≥60	four	≥9	≤30	twenty-one	twelve thousand
MFZ12-90YC	12 24 110 220	≥90	four	≥9	≤36	twenty-one	twelve thousand

Order code

Valve electromagnet	direct current	Design Number	Rated suction force (Kgf)	wet type
MF	Z	twelve	22/25/37/60/90	YC

MFZ12-YC series DC wet valve solenoid stroke force characteristic curve

MFZ12-YC series DC wet valve electromagnet appearance and installation dimensions

Precautions for use
The electromagnet adopts sockets that comply with the ISO4400 standard. There are two specifications with and without indicator lights, you can choose according to your needs. The voltage specifications of sockets with indicator lights often need to match the voltage specifications of the electromagnet body.
The manual push rod of the electromagnet is used for manual control during debugging or emergency situations. But when the system back pressure is high and adjustment is difficult, please use a cross screwdriver to slowly push the manual push rod. It is not advisable to use impact force to avoid damaging the surface of the manual push rod and guide inner hole, causing electromagnetic oil leakage or inability to reset.
When using electromagnets in both directions, it is necessary to ensure that both electromagnets cannot be energized at the same time to prevent the solenoid valve from working properly.
An overcurrent protection device should be installed between the electrical control system and the connection part of the electromagnet to prevent the electromagnet and your electronic control components from being burned out under abnormal conditions.
When the power supply is AC, MFB12-YC AC integral electromagnetic coil can be used, which has the same performance as MFZ12-YC and can reduce the system noise level.