MFB12-YC series AC integral wet valve electromagnetic coilDetailed product description：

The MFB12-YC series AC integral wet valve electromagnet is suitable for control circuits with DC 50H and voltage up to 220V. As a power component of hydraulic solenoid directional valve. Can be matched with YUKEN six and ten way diameter junction box threaded electromagnetic directional valve from Japan.

Normal working conditions
Can be installed in any direction.
There should be no gas or dust in the usage environment that can corrode metals and damage insulation. Otherwise, it may affect the product's lifespan.
Electromagnets are suitable for long-term and intermittent cycle working systems.
The reasonable fluctuation range of power supply voltage is 85% -110% (special requirements can be raised when ordering).
The enclosure protection level is IP65.

MFB12-YC series AC integral wet valve electromagnetic coil main technical parameters

model	Rated voltage (V)	Rated suction (N)	Rated stroke (mm)	Full stroke (mm)	Power consumption (W)	Enduring static oil pressure (MPa)	Operating frequency (T/h)
MFB12-22YC	110 220	≥22	two point eight	≥6	≤30	twenty-one	twelve thousand
MFB12-25YC	110 220	≥25	two point eight	≥6.1	≤26	twenty-one	twelve thousand
MFB12-37YC	110 220	≥37	two point eight	≥6.1	≤30	twenty-one	twelve thousand
MFB12-60YC	110 220	≥60	four	≥9	≤30	twenty-one	twelve thousand
MFB12-90YC	110 220	≥90	four	≥9	≤36	twenty-one	twelve thousand

Order code

Valve electromagnet	Communication book	Design Number	Rated suction force (Kgf)	wet type
MF	B	twelve	22/25/37/60/90	YC

Travel force characteristic curve

MFB12-YC series AC integral wet valve electromagnetic coil appearance and installation dimensions

Precautions for use
The electromagnet adopts sockets that comply with the ISO4400 standard. There are two specifications with and without indicator lights, you can choose according to your needs. The voltage specifications of sockets with indicator lights often need to match the voltage specifications of the electromagnet body.
The manual push rod of the electromagnet is used for manual control during debugging or emergency situations. But when the system back pressure is high and adjustment is difficult, please use a cross screwdriver to slowly push the manual push rod. It is not advisable to use impact force to avoid damaging the surface of the manual push rod and guide inner hole, causing electromagnetic oil leakage or inability to reset.
When using electromagnets in both directions, it is necessary to ensure that both electromagnets cannot be energized at the same time to prevent the solenoid valve from working properly.
An overcurrent protection device should be installed between the electrical control system and the connection part of the electromagnet to prevent the electromagnet and your electronic control components from being burned out under abnormal conditions.