710 type accumulation counterDetailed product description：

The 710 type accumulator counter has strong anti-interference ability and is easy to use. 6-digit red digital display with zero blanking function. The counter can be driven by voltage pulses, proximity switches, photoelectric switches, shaft encoders, or mechanical shock switch signals to count.  
If the power supply is interrupted, the recorded values will be stored in a permanent memory (NVRAM), which can hold the recorded data for at least one year under five power conditions. Therefore, when the power is restored, counting can continue with partial loss.

Technical parameters of 710 type accumulator counter:

character height	7mm
rated voltage	DC12-24V ± 10% AC220V ± 10% (with power pack)
power consumption	120mA
data saving	≥ 1 year
counting method	incremental
Maximum counting frequency	Set to 30Hz or 5KHz according to the application settings
Minimum Counting Pulse Width	100us
Trigger method	Positive and negative edges can be set as needed
pulse mode	arbitrary
Threshold voltage amplitude	Low level ≤ 2V High level ≥ 8V
maximum extent	±40V
input impedance	15 euros
control input	Suppression gate/reset
Prohibit signal holding time	>100ms
Zero signal holding time	>250ms
Operating Temperature	-10℃—+50℃
Storage temperature	-20℃—+70℃
Protection category	Front IP40, rear IP100
anti-interference capability	Interference intensity level 2
Installation method	Plug in (400 module series)
quality	About 57g

Counting and reset signals		Input signal frequency
Positive edge trigger	Negative edge trigger	5KHz	30Hz	Order Number
※		※		0710403
※			※	0710404
	※	※		0710413
	※		※	0710423

Product installation dimension diagram:

710 type accumulator counter