C2000G-100 Isolation switchDetailed product description：

C2000G-100 isolation switch has high dynamic and thermal stability, mainly used as the main switch in terminal combination appliances, suitable for distribution and control circuits with AC 50Hz or 60Hz, rated voltage of 400V and below, and can also be used to control motors, low-power appliances and lighting. It is widely used in industrial and mining enterprises, high-rise buildings, commercial and household places.
This product complies with IEC60947-3 and GB14048.3 standards.

2. Main technical parameters

Compliant with IEC60947-3 and GB14048.3
Rated voltage: AC 230/400V
Rated current: 32, 63, 100A
Electrical lifespan:

Rated current (A)	Electrical lifespan (times)
thirty-two	three thousand
sixty-three	two thousand
one hundred	one thousand

Short circuit carrying current capacity: 20In/1s
3. Environmental conditions for use
The ambient air temperature ranges from -5 ℃ to+40 ℃, with an average temperature not exceeding+35 ℃.
The altitude shall not exceed 2000m.
When the relative temperature of the atmosphere is+40 ℃, it does not exceed 50%, and the hottest month is 90%.
Pollution level is level 2
Use category AC-22A
Installation categories are II and III.
The installation form adopts TH35-7.5 steel installation rail installation, and the inclination between the installation surface and the vertical surface does not exceed 5 degrees.

4. Structural characteristics

Small size and long lifespan
The contact opening and closing have prominent color markings to prevent accidental operation
Adopting a "frame" wiring structure - safe and reliable wiring
Adopting a high flame retardant, high temperature resistant, and impact resistant shell
Modularization facilitates quick installation and replacement

The switch should be installed vertically, with the upper end connected to the power supply and the lower end connected to the outgoing line. Push up the handle to connect and display in red, pull down to disconnect and display in green, do not connect in reverse.
Before powering on, manually operate several times to ensure that the mechanism operates flexibly and reliably without any obstruction.