DGL series load isolation switchDetailed product description：

DGL series load isolation switch

The DGL load isolation switch can reliably operate under the following conditions

The altitude does not exceed 2000 meters;
The ambient temperature shall not exceed 40 ℃ and shall not be lower than -5 ℃;
Relative humidity not exceeding 95%;
◎ Non explosive hazardous medium environment;
◎ No rain or snow invasion environment;
Note: If expected to be used under conditions where the ambient air temperature is above+40 ℃ or below -5 ℃ to -45 ℃, the user should inform the manufacturer

purpose

AC 50Hz, rated voltage up to 660V, DC rated voltage up to 440V, rated current up to 1600A. Used for infrequent connection and disconnection of circuits.

DGL-125A-4000A load - isolating switch
DGL load isolation switch with 15 specifications from 125A to 4000A is a modular design basic type, with three poles and four poles (three poles+switchable neutral pole), suitable for circuit and connection and disconnection or electrical isolation, and only for electrical isolation above 1000A.
There is a marking window on the front to indicate the on/off status of the contacts.
According to the needs, a rear observation window can be provided to directly observe the on/off status of the contacts. The window style is shown in DGL 125A~1600A/H cabinet rear operating load - isolation switch.

Operation method
Direct operation: The handle is installed directly in the middle of the switch.
External operation: The handle is installed outside the distribution cabinet door.
Can be equipped with two sets of auxiliary contact points.
DGL-125A-4000A Electrical and Mechanical Properties


DGL-125A-4000A Electrical and Mechanical Properties

DGL-125~630A load isolation switch appearance and installation dimensions

DGL-1000A~4000A load isolation switch appearance and installation dimensions