DX-11Q,11A/Q,11B/Q,11C/Q type signal relayDetailed product description：

DX-11Q, 11A/Q, 11B/Q, and 11C/Q signal relays are used as signal indicators in DC operated protection circuits.

2 Structure and principle
This relay has an electromagnetic coil, three sets of movable contact points with a common point, and a signal board. It is an electromagnetic snap on relay and should be installed on a vertical panel.
The DX-11Q has an electromagnet, three sets of moving contact points with a common point, and a signal board. The DX-11A/Q relay has an electromagnet, two sets of moving contact points, and a signal board. The DX-11B/Q relay has an electromagnet, two sets of moving contact points, and a signal board.
The DX-11C/Q type relay has an electromagnet, a pair of movable contacts, a pair of movable contacts, and a signal board.
The internal wiring diagram of the above relay is shown in Figure 1.

Top left is DX-11Q, top right is DX-11A/Q
The bottom left is DX-11B/Q, and the bottom right is DX-11C/Q
Figure 1 Internal wiring diagram of relay (back view)

3 DX-11Q, 11A/Q, 11B/Q, 11C/Q Signal Relay Technical Data
3.1 The rated data of relays are listed in Table 1 (for current type relays) and Table 2 (for voltage type relays).
3.2 The power consumption of current type relays is about 0.3W, while the power consumption of voltage type relay coil circuits is about 2W.
3.3 Under the condition of instantaneous return of the relay, when the voltage is below 250V and the current is below 2A, the breaking capacity of the contacts is 50W in DC circuits with inductive loads and 250VA in AC circuits.
3.4 The circuit of the relay should withstand AC 50Hz and voltage 2kV for 1 minute to test the dielectric strength of the casing.
The weight of the 3.5 relay is approximately 0.5kg
The appearance and installation dimensions of the 3.6 relay are shown in Figure 2.


Figure 2 Appearance and installation dimensions of DX-11Q, 11A/Q, 11B/Q, 11C/Q signal relays

3.7 For 220V coils with a wire diameter greater than 0.09, short-term power supply is considered; for coils with a wire diameter less than 0.09, long-term power supply is considered.

Rated current (A)	Long term current (A)	Action current (A)	Coil resistance (V)
zero point zero one zero point zero one five zero point zero two five zero point zero five zero point zero seven five zero point one zero point one five zero point two five zero point five zero point seven five one	zero point zero three zero point zero four five zero point zero seven five zero point one five zero point two two five zero point three zero point four five zero point seven five one point five two point two five three	Not exceeding 95% of rated current	two thousand and two hundred one thousand three hundred and twenty eighty-four thirty eighteen eight three zero point seven zero point three five zero point two

Rated voltage (V)	Long term voltage (V)	Action voltage (V)	Coil resistance (V)
two hundred and twenty one hundred and ten forty-eight twenty-four twelve	two hundred and forty-two one hundred and twenty-one fifty-three twenty-six point four thirteen point two	Not exceeding 70% of the rated voltage	thirty-one thousand and five hundred seven thousand and five hundred one thousand four hundred and forty three hundred and sixty eighty-seven

Ordering Instructions for DX-11Q, 11A/Q, 11B/Q, 11C/Q Signal Relays
4.1 Name and model of relay.
4.2 Rated current or voltage.