SH/BLC8610 explosion-proof road lightDetailed product description：

survey:
SH/BLC8610 explosion-proof road light (Ⅱ C) is suitable for road lighting in various flammable and explosive places such as petroleum and chemical industries.

Performance:
The explosion-proof type has the highest explosion-proof level and can be safely used in various flammable and explosive places.
Using high-efficiency HPS dual tube gas discharge lamp as the light source, with good fog transmission and a lifespan of up to 50000 hours; Intelligent circuit design, the light bulb can start instantly without cooling.
Adopting high-tech surface spraying treatment, it is rainproof, corrosion-resistant, and will never rust; The transparent component adopts the latest photocatalyst nano material, which can automatically decompose stains, does not stick to oil, and ensures the illumination brightness of the lamp.
The shell is made of special high hardness alloy material, with multiple shock-absorbing structures, and has extremely strong shock and impact resistance, which can be used for a long time in various harsh outdoor environments.

Two uses:
1. Thread the cable equipped with the lamp into the pole, then fit the lamp body onto the 60mm pole through the clamping ring, adjust the direction of the lamp, and tighten the bolts on the clamping ring to fix the lamp.
2. Install the explosion-proof ballast box into the base at the bottom of the pole, open the ballast cover and loosen the clamping nut of the inlet, and thread the lamp cable into the ballast box for wiring. Attention: The red wire is connected to the 4th terminal of the wiring block, the black wire is connected to the 5th terminal of the wiring block, and the yellow green wire is connected to the 6th grounding terminal.
3. Loosen the compression nut of the other inlet of the ballast box and thread the input power line into the ballast box for wiring. Attention: The live wire is connected to terminal 1, the neutral wire is connected to terminal 2, and the grounding wire is connected to terminal 3. After all the wires are connected, tighten all the compression nuts on the ballast box, cover the ballast box and tighten the bolts on top. Connect a grounding wire to the grounding terminal outside the ballast to start working.

Three notes:
1. Before turning on the lighting fixtures, the power must be turned off.
2. Special tools must be used to turn on the lighting fixtures.

Technical parameters of SH/BLC8610 explosion-proof road light (Ⅱ C):
Rated voltage: 220VAC 50Hz
Shell protection: IP65
Inlet thread: G3/4
Cable introduction: 8mm to 14mm
Dimensions: 540 × 364 × 192mm
Total weight: 11Kg