CT25□ Type Operating MechanismDetailed product description：

Overview
This product is specially designed for FZ25-12 indoor high-voltage vacuum load switch, which replaces the original one with a separate one, making installation convenient and maintenance simple This product uses both electric and manual operation methods for energy storage and closing. There are two ways to open the circuit: by using an electromagnetic switch or a manual button. The mechanical lifespan is over 10000 times

Main technical parameters
1. The opening electromagnet powered by an independent power source adopts a spiral tube electromagnet, and its technical parameters are shown in the table below:

model	rated voltage	Rated voltage output power	Normal operating voltage range
53ZY-CJDO1B	-220V	40W	85% -110% rated voltage

If the user needs AC power supply, a full wave rectification power supply (bridge stack) is used to rectify and supply the energy storage motor for operation.
2. The opening electromagnet powered by an independent power source adopts a spiral tube electromagnet, and its technical parameters are shown in the table below:

Rated working voltage (V)	-220	-110	-220	-110	-48
Rated working current (A)	two point six seven	six	two point eight two	five point eight five	nine point six
Rated electrical rate (W)	<587	six hundred and sixty	six hundred and twenty	<643.5	four hundred and sixty point eight
Coil resistance value at 20 ℃ (Ω)	30±3	6.1±0.6	78±7.8	eighteen point eight	five
Normal operating voltage range	65% -120% of the rated working voltage should be reliably tripped, Do not disconnect when the rated operating voltage is less than 30%

3. The output of the institution is 60-80J;
4. The working angle of the output shaft of the mechanism is about 44 degrees.
5. CT25 spring operated mechanism can be classified into two types based on installation and operation methods: front mounted side operation and reverse mounted side operation.
Outline and Installation Hole Diagram

Note: If users have special requirements, they can negotiate with our factory to determine.