GJ-WT(G) series thyristor solid-state voltage regulator moduleDetailed product description：

GJ-WT (G) series thyristor solid-state voltage regulator module

Features:
The GJ-WT (G) series thyristor solid-state voltage regulator module is mainly used in electronic products such as temperature control and dimming. It has the characteristics of small size, long lifespan, high control power, and high insulation voltage between the wiring terminals and the base plate.

Product Model	GJ10-40A-WT
control type	Potentiometer adjustment value
conduction angle scope	00 ~1700
peak voltage	≥600VAC
insulation voltage	≥2500VAC
inrush current	90A	230A
Broken state leakage current	≤5mA	≤7mA

Product Model	GJ10-40A-WTG
control type	3~15VDC
output voltage scope	0 ~220V
peak voltage	≥600VAC
insulation voltage	≥2500VAC
inrush current	90A	230A
Off state leakage current	≤5mA	≤7mA

type number	negative load electricity press V	negative load electricity flow A	outside form
GJ10—WT	24 —240V	ten
GJ20—WT	24 —240V	twenty
GJ40—WT	24 —240V	forty
GJ10—WTG	0—220V	ten
GJ20—WTG	0—220V	twenty
GJ40—WTG	0—220V	forty

Instructions for use:
1. Select a solid-state voltage regulator of appropriate specifications based on the load power, and equip it with a suitable fast fuse to meet the usage requirements.  
When the current is high, add a heat sink as required or fix it on a metal base plate of the corresponding area. Apply thermal conductive silicone grease to the installation surface and pay attention to ventilation and heat dissipation.  
If there is severe RF interference, an inductive coil can be connected in series in the load circuit.  
4. External potentiometer, can be supplied as a set or purchased by the user. It is required to be connected to a WX-2W potentiometer with a resistance of about 680K.  
5. WT type: Input and output are not insulated. Please pay attention to safety during use and do not touch the module and potentiometer contact terminals.