FHP series puncture type lightning protection needle insulatorDetailed product description：

FHP series puncture type lightning protection needle insulator

With the promotion and application of insulated overhead distribution lines, if necessary and effective lightning protection measures are not taken, the phenomenon of lightning strikes, wire breakage, and insulator burnout caused by direct lightning and induced lightning on insulated lines may occur. Our company applies the principle of external gap arc ignition lightning protection to needle insulators, and adopts a patented puncture type structure and a unique arc ignition device structure (which can be replaced and repaired separately). It is easy to install (no need to peel off the insulation layer), has excellent performance (self weight compression contact), and is simple and beautiful (with silicone rubber insulation cover). It not only plays the role of a needle insulator, but also has the function of preventing lightning strikes and wire breakage. It is suitable for the installation of 10-20kV overhead insulated new lines or the improvement of old lines, and has great promotion value.

Model Description


Technical parameters and selection table of FHP series puncture type lightning protection needle insulator

Product Model	Rated voltage kV	Rated bending load kN	Steel foot installation size mm	Power frequency withstand voltage kV	Lightning impulse 50% discharge voltage kV	Applicable wire specifications	Insulation layer thickness (mm)	Applicable torque (N * m)
FHP-10/5T20C-1	ten	five	twenty	≥45	≤12	JKLY-50～120	3~4	twenty-three
						JKLGY-35/6～95/20
FHP-10/5T20C-2	ten	five	twenty	≥45	≤120	JKLY-120～240		twenty-six
						JKLGY-120/7～185/45
FHP-10/5T20C-3	ten	five	twenty	≥45	≤12	JKLY-300		twenty-eight
						JKLGY-240/30～240/40
FHPQ-20/12.5T22C-1	twenty	twelve point five	twenty	≥70	≤170	JKLY-50～120	6~7	twenty-six
FHPQ-20/12.5T22C-2	twenty	twelve point five	twenty	≥70	≤170	JKLY-120～240		twenty-eight
FHPQ-20/12.5T22C-3	twenty	twelve point five	twenty	≥70	≤170	JKLY-300		thirty

Note:
1. If the installation size of the steel feet is different, please indicate it when ordering. 2. If used for bare wires, do not include the letter C. 3. Other products have the same performance as composite insulators of the same specifications.
4. If the thickness of the insulation layer of the wire is not within the specified range, please indicate it when ordering and do not misuse it, otherwise it may cause poor electrical contact or damage to the wire.